Nail Grenade by the Jolly Roger Effective fragmentation grenades can be made from a block of tnt or other blasting explosive and nails. Material Required: ----------------- Block of TNT or other blasting explosive Nails Non-electric (military or improvised) blasting cap Fuse Cord Tape, string, wire, or glue Procedure: --------- 1) If an explosive charge other than a standard TNT block is used, make a hole in the center of the charge for inserting the blasting cap. TNT can be drilled with relative safety. With plastic explosives, a hole can be made by pressing a round stick into the center of the charge. The hole should be deep enough that the blasting cap is totally within the explosive. 2) Tape, tie, or glue one or two rows of closely packed nails to the sides of the explosive block. Nails should completely cover the four surfaces of the block. 3) Place blasting cap on one end of the fuse cord and crimp with pliers. NOTE: To find out how long the fuse cord should be, check the time it takes a known length to burn. If 12 inches (30 cm) burns for 30 seconds, a 10 second delay will require a 4 inch (10 cm) fuse. 4) Insert the blasting cap in the hole in the block of explosive. Tape or tie fuse cord securly in place so that it will not fall out when the grenade is thrown. Alternate Use: ------------- An effective directional anti-personnel mine can be made by placing nails on only one side of the explosive block. For thi case, and electric blasting cap can be used. ------------------Jolly Roger