From: dgb@owlnet.rice.edu (Dennis Gale Brown) Newsgroups: rec.games.video.sega This is an article I wrote last year to post here. I'm posting it again. This is probably not the best way to hook up the Genesis to a monitor but it works. I have no clue what the "new" Genesis is like, so this may or may not work with it. ------------------------------------------------------------------------------- Here's how I hooked up my Genesis to my NEC Multisync II: First, I went to Radio Shack and bought the following parts: 274-026 8-pin DIN plug (Genesis end) 276-1427 9 Position D-shell MALE connector 276-1513 Hood for above 278-775 9-conductor wire (sold by the foot; I got 3') Then I checked out the Genesis Monitor pinout from the FAQ: (looking at port itself) 1 . 8 . 7 2 . . . 6 3 . . 5 4 ' (these numbers probably aren't correct but they match my list below!): 1 - Negative Combined Sync 2 - Composite Video 3 - Green 4 - Ground 5 - +5 Volts 6 - Audio 7 - Red 8 - Green Then I checked out the pinout for the Multisync: 1 2 3 4 5 . . . . . . . . . 6 7 8 9 2 - Sync 3 - Blue (analog) 4 - Green (analog) 5 - Red (analog) 6 - Ground (again, numbers are probably wrong, and this isn't the full pin-out, but it's enough) After this, it's just a matter of putting things together. Using the 8-pin DIN connector requires some soldering, but the 9-pin connector I chose can simply have the pins clamped onto the wires. One note: You may have to bend the pins in the 8-pin connector slightly to make it fit in the Genesis. I had to bend the middle pin down a bit and the two top pins outward. After that, no problem. Final word: Do this at your own risk. This probably isn't the best way to go about this, but it does work. If your equipment blows up, don't blame me! Have fun... BTW, If you have a different monitor, I can't help you. All I can say is that if it works with an Amiga 500/1000/2000, it probably works with the Genesis (similar if not identical scan rates), provided you have the correct pinouts and connectors...