======================================= [ Hacker Supreme - Hack Directory #19 ] ======================================= (info Uploaded to The Cartel AE Line.) Mobile Telephone Communications Mobile telephone communications is not the same thing as Cellular. Mobile telephone service is not as advanced as Cellular, and not as efficient. Mobile telephone service limits the number of customers sharply, while Cellular is designed to solve the problems of Mobile telephone service. The signals for Mobile communications are sent by high-power transmitters and antennas that provide an area of approx. 20-30 miles with service. A base unit of a Mobile communications system transmits and receives on different frequencies at the same time. Typical power for the radio base station transmitter is 200-250 watts. Mobile telephone facilities tie in with the normal fixed-position telephone system, however base units can be owned by a Radio Common Carrier (RCC). RCCs running mobile telephone systems are charged by the telephone company for use of the normal phone system. DIAGRAM: -------- ^-Base antenna Mobile unit | | |- - - - - - - - - /-- --\ | ^Signal^ | (Car) | --------------------------------------- ^-------<-20-30 Miles->---| ^ |-From /===========\ | mobile |Receiver/ | | antenna |Transmitter| ============= /===========\ |Receiver/ | |-| |Control | |Transmitter|-|*| |Terminal | ============= |-| \===========/ ^ | Handset | <-Telephone | <-Land line | ======= ======= | C.O.| | C.O.|---[-*-] ======= ======= |*| | | ----- | | Fixed ========= ========= Phone |Switch |--------------|Switch | |Network| Transmission |Network| ========= Link ========= --------------------------------------- (Above diagram from 'Understanding Telephone Electronics' chapter 10.) As you can see from the above diagram, calls placed from the Fixed position telephone are routed through a Central Office as normal, through a Switch Network, to another Switch network, and to another CO. From the second CO (nearest to the Mobile unit), the signals are sent on a telephone line to the control terminal, to the receiver, then to the base unit (antenna). From the base unit, the radio signals are sent to the site of the mobile telephone. Calls from the mobile telephone operate in the same manner. An idle radio channel is selected (like seizure of a trunk for a LD call) and the signals are sent over the mobile network. If no channel is available for use, then a busy indication is triggered (similar to a re-order). If a channel is available, the customer will be prompted with a dial tone, similar to normal fixed-position telephone service. The area that this would work in is called the subscriber's home area. When a mobile telephone service subscriber leaves the service area, he is then referred to as a Roamer. Since the mobile unit is out of the service area, special preparations have to be made to continue communications to/from that mobile unit. SIGNALLING ---------- Mobile signalling tones are selected (like touch tones) to avoid possible reproduction of the signalling tone on the voice link, to cause a signalling mistake. The IMTS (Improved Mobile Telephone Service) uses in band signalling of tones from 1300Hz-2200Hz. Another method of signalling is the MTS (Mobile Telephone System). MTS is older than IMTS, and MTS uses in band signalling of tones from 600Hz-1500Hz, and some use 2805 Hz in manual operation. CALL COMPLETION --------------- In this instance, let's say a call is being placed from a normal telephone to a Mobile unit. First off, the base station selects one idle channel and places a 2000Hz idle tone on it. All on hook Mobile units active in that service area find and lock onto the channel that carries the 2000Hz idle tone. Now each Mobile unit listens for it's specific number on that channel. When an idle channel becomes busy, a new channel is selected for use, and the process is repeated. Now the caller's call is sent through the telephone network the same way as a normal telephone call. When this call reaches the control terminal, the terminal seizes the already marked idle channel (with every on-hook mobile unit listening to it) and applies a 1800Hz seize tone. This tone keeps other mobile units from using it to complete other calls. The called number is outpulsed over the base station transmitter at ten pulses per second, with idle tone represented as a mark, and a seize-tone represented as a space. Since every idle mobile unit is waiting on that channel, they compare the number being outpulsed with their own number. If the first digit of the called mobile unit is three, and a specific mobile unit 'listening' on the channel has a first digit of four, it stops listening to that channel, and moves to the next channel with 2000Hz applied. When the mobile unit receives the correct destination number, all other mobile units are no longer listening on that particular channel. When the 7 digit number is received, the mobile supervisory unit turns on the mobile transmitter and sends an acknowledgement signal (2150Hz guard tone) back to the control terminal. If this signal isn't received in three seconds after outpulsing, the seize tone is removed from that channel, and the call is dropped. If the signal is received at the control terminal, then the mobile phone will ring (standard two seconds on, four seconds off). If the mobile unit being called doesn't answer in forty five seconds, the call is also dropped. When the person answers the mobile phone and takes it off hook, the mobile supervisory unit sends a connect tone of 1633Hz, for an answer signal. When this is received by the control terminal, the ringing stops, and a voice path between the two phones is established. When the mobile subscriber hangs up, a disconnect signal is sent which consists of alternating disconnect/guard tone (1336Hz and 2150Hz respectively) signals. Then the mobile unit begins searching for another idle channel, and readies itself for more calls. For an outgoing call placed by the Mobile subscriber, the mobile unit must already be locked on the idle channel. If the unit is not, a warning light will flash advising the user of the problem. This is similar to a re-order signal. If the unit is already on an idle channel, the calling number will be sent to the control terminal for billing purposes. CELLULAR TELEPHONES ------------------- To improve over the problems of mobile telephone service such as low amount of users, high price, etc. AT&T invented the Cellular Concept, or the AMPS (Advanced Mobile Phone System). This is the cellular phone concept that is used in major cities. Los Angeles, Ca. currently has the largest cellular communication system in the world. Calls sent to cellular telephones are sent through the MTSO (Mobile Telecommunications Switching Office). The MTSO handles all calls to and from cellular telephones, and handles billing. All incoming calls from the MTSO are sent to a Cell site in each cell, to the actual cellular telephone. The major difference between mobile and cellular is that cellular can use the same channel many more times than a mobile telephone system can, providing more customers and making the service less expensive. Once a vehicle goes out of range of one cell site, the signal is transferred immediately, with no signal loss, to another cell site, where the call is continued without interruption. This is called a Cellular hand-off. Cellular communications areas are divided up into several cells, like a honeycomb. DIAGRAM ------- /---\ /---\ /---\ / * \/ * \/ * \ ==== |Cell ||Cell ||Cell | |CO| | Site|| Site|| Site | ==== /---\\ /\ /\ / | / * \\---/ \---/ \---/ | |Cell | /---\ /---\ | | Site|/ * \/ * \ | \ /|Cell ||Cell | ====== \---/ | Site|| Site | |MTSO| \ /\ / ====== \---/ \---/ --------------------------------------- More cell sites are used for the area they are needed for. The signals are sent from the MTSO to the each cell site. So if you were travelling in the cell site to the far left, the signal from the MTSO would be sent to that cell. As you move, the signal is moved. Here is a quote from AT&T's Cellular Telephones pamphlet. 'AT&T cellular phone transmission sounds as good as your home and office phone. Basically it's a simple concept. Each metropolitan area is divided into sectors which form a honeycomb of cells. Each cell incorporates its own transmitter and receiver which connects to the local phone network. As you drive from cell to cell, sophisticated electronic equipment transfers or 'hands off' the call to another cell site. This automatic sequence maintains service quality throughout the conversation without interruption.' I hope this file has been of some assistance to anyone who is curious about the more technical aspects of the telephone system. References ---------- Understanding Telephone Electronics-by Texas Instruments 1983 TELE Magazine issues three and four AT&T Mobile communications pamphlet AT&T Cellular concept pamphlet CENTREX/CENTRON CALL FORWARDING (CONTINUED FROM TSR ISSUE #1) IN THE FIRST ARTICLE ON CENTREX/CENTRON CALL FORWARDING, I STATED I WOULD LIST A FEW ALTERNATE ACCESS CODES IN THE 5 STATE AREA. IF YOU NEED THE ALTERNATE ACCESS CODES IN YOUR AREA, TRY TO CONTACT ME ON MOST ASCII EXPRESS LINES. ALTERNATE LOCATION CENTREX/CENTRON ACCESS CODE -------------------------- ----------- IOWA SIOUX CITY (712-279) 8 COUNCIL BLUFFS (712-328) 8 DES DOINES-NORTHWEST (515-270,278) 8 "" "" -DWTN. (515-286) 110 "" "" -ASHWORTH (515-223) 8 "" "" -EAST (515-263) 111 WATERERLOO (319-291) 8 DAVENPORT 319-383) 8 CEDAR RAPIDS (319-399) 8 MINNESOTA MPLS.-DWTH. (612-344) 101 PLYMOUTH (612-536) 101 GOLDEN VALLEY (612-542) 111 BLOOMINGTON (612-887) 101 ST. PAUL-MIDWAY 111 NEW BRIGHTON (612-631) *19 ST. PAUL-SHOREVIEW (612-482) 101 ST. PAUL-DWTN. (612-221) 111 ST. CLOUD (612-255) 101 ROCHESTER (507-285) 111 BRAINERD (218-828) 111 NEBRASKA OMAHA-DWTN. (402-422) 101 OMAHA-IZARD (402-554) 101 OMAHA-FORT (402-496) 101 GRAND ISLAND (308-381) 8 NORTH DAKOTA FARGO (701-247) 8 BISMARK (701-222) 8 SOUTH DAKOTA RAPID CITY (605-394) 115 ABERDEEN (605-622) 115 SIOUX FALLS (605-339) 115 TWO ADDITIONAL LOCATIONS ARE SCHEDULED FOR CONVERSION TO CENTRON SERVICE SOON AND WILL BE REQUIRED TO USE THE ALTERNATE ACCESS CODE FOR CALL FORWARDING AT THAT TIME. IOWA DUBUQUE (319-588) 8 DUE LATE JUNE'86 NEBRASKA NORFOLK (402-644) 8 DUE MID JULY'86 =========================================================================== COMPETITIVE PHONE COMPANYS REACT: MCI AND GTE SPRINT ANNOUNCED PLANS TO REDUCE THEIR LD RATES EFFECTIVE JUNE 1. THE TWO COMPANIES SAID THEIR RATES WOULD BE COMPETITIVE WITH AT&T, WHICH HAD BEEN EARLIER ANNOUNCED IN TSR ISSUE #1 OF THE RATE CUT ALSO EFFECTIVE JUNE 1. INCLUDING 11.4 PERCENT FOR DAY AND EVENING HOURS AND MANY OTHER SIMILAR REDUCTION. =========================================================================== NWB'S INTRO TO 'SMART PHONES': NORTHWESTERN BELL'S PUBLIC SERVICES LINE OF BUSINESS IS FIELD TRIALING A NEW COIN PHONE PRODUCT - ONE IT HAD A HAND IN CREATING. THE NEW COIN PHONE PRODUCT IS THE NBT(TM) 1062 COIN PHONE RETROFIT KIT DESIGNED BY NWBELL TECHNOLOGIES. THE KIT CONVERTS STANDARD PUBLIC COIN PHONES - DEPENDENT ON CENTRAL OFFICE ELECTRONICS - INTO "STAND ALONE" COIN PHONES, WHICH HAS BEEN LABELED BY CODENAME AS "SMART PHONES." THERE ARE MANY NEW FEATURES OF WHICH CUSTOMERS WILL NOT NOTICE. ALTHOUGH THE ONLY NOTICEABLE CHANGE BETWEEN THE RETROFITED COIN PHONES AND THE RADITIONAL PUBLIC COIN PHONES IS THE VOICE IN THE RETROFITED MODE, GENERATED BY THE KIT'S ELECTRONIC CIRCUIT BOARD. IT INSTRUCTS USER TO DEPOSIT MONEY. CURRENTLY THE SMART PHONES ARE BEING TESTED IN 40 COIN PHONES AROUND THE NORTHWESTERN BELL. =========================================================================== LOCAL AREA NETWORKS (LAN): A LOCAL AREA NETWORK IS A SYSTEM OF HARDWARE AND SOFTWARE THAT CONNECTS A VARIETY OF SIMILAR AND DISSIMILAR COMMUNICATIONS DEVICES. THESE DEVICES TYPICALLY ARE OPERATED BY A SINGLE COMPANY FOR INTERNAL USE WITHIN A LIMITED GEOGRAPHICAL AREA. THE SYSTEM ALLOWS HIGH SPEED COMMUNICATIONS BETWEEN DEVICES ON THE NETWORK WHILE MAINTAINING DATA SECURITY, BELL SO BOLDLY CLAIMS. A VARIETY OF TRANSMISSION MEDIA ARE AVAILABLE IN THE LAN MARKETPLACE. THESE CATEGORIZE THE MAJOR TYPES OF LOCAL AREA NETWORKS IN USE PRESENTLY. THE MOST PREVALENT ARE TWISTED PAIR (COPPER) AND FIBER OPTIC CABLE. BECAUSE OF ITS SUPERIOR TRANSMISSION CAPABILITIES, FIBER IS CONSIDERED TO BE THE MEDIA OF CHOICE FOR THE FORESEEABLE FUTURE WITHIN BELL. =========================================================================== ----------------------------------------------------------------------------- Another Great Directory from Hacker Supreme. (Ninja Squirrel /+\, Logan - 5, Zaphod Breeblebox, Silicon Rat, Lord Vision.) ----------------------------------------------------------------------------- ============================================================================== [ Infinity-Cartel Network ] [ The Cartel Adventure/AE/Hack BBS 5.5 meg --- 206-825-6236, or 206-939-6162 ] [ Infinity's Edge Adventure/AE/Cat/Hack 10 meg BBS ------------ 805-683-2725 ] ============================================================================== ] [ The Cartel Adventure/AE/Hack BBS 5.5 meg --- 206-825-6236, or 206-939-6162 ] [ Infinity's Edge Adventure/AE/Cat/Hack 10 meg BBS ------------ 805-683-2725 ] =================